Controls And Indicators - Harman JBL ONBEAT VENUE Guía De Instalación Rápida

PLACEMENT
Place OnBeat Venue on a shelf or table with the rear of its enclosure is at least 3" (76mm)
away from a wall or other surface to allow the bass ports to operate properly.

CONTROLS AND INDICATORS

Bass Boost
Button
Bass Boost button: Press this button to enhance the bass performance. The button's
LED will illuminate when Bass Boost is on.
Movie button: Press this button to activate the Movie EQ mode, which creates an
extra-wide sound field to compliment films and other video media. The button's LED will
illuminate when the Movie mode is on.
Source button: Press this button to cycle through the audio sources: Bluetooth, iPod/
iPhone/iPad dock and Aux Input. The input LED for the active source will illuminate.
• If you begin to stream audio from a paired Bluetooth device or play audio from a
device connected to the dock while another source is playing, the OnBeat Venue will
automatically switch to the new source.
Aux Input LED: This LED illuminates when the Aux Input is the active source.
Dock Input LED: This LED illuminates when the iPod/iPhone/iPad dock is the active
source.
Bluetooth LED: This LED flashes blue when the OnBeat Venue is in the Bluetooth pairing
mode, and turns solid blue when it has successfully paired with a Bluetooth device.
Power button: When the OnBeat Venue is on, press the Power button to put it into the
standby mode. The button's LED will illuminate solid amber when the unit is in standby.
When the OnBeat Venue is in standby, press the Power button to turn it on. The button's
LED will illuminate solid white when the unit is on.
2
Dock Input
LED
Movie Aux Input
Button LED
Source
Button
Bluetooth
LED
Power Volume Up/Down
Button Buttons
Docking Slide (open)
Docking Connector