Harman JBL ONBEAT VENUE Guía De Instalación Rápida página 3

When the OnBeat Venue is in the standby mode it will automatically turn on when it detects
audio playing from a Bluetooth-connected device or from a docked device.
When the OnBeat Venue is on, it will automatically enter the standby mode after 10 minutes
of inactivity (no audio input and no user-control operation).
Note: When the OnBeat Venue enters the standby mode it will also bring a docked device
into standby mode.
Volume Up/Down buttons: Press these buttons to raise and lower the OnBeat Venue's
volume. To mute the sound, press both buttons at the same time. (The Power button LED
will flash white when the sound is muted.) To restore the sound press both Volume buttons
together.
Docking slide: Press in on the JBL logo to open the docking slide and pull the slide all
the way open.
Docking connector: Place your device onto the docking slide so that it is firmly seated
on the docking connector.
Note: We recommend that you disable the"Shake to Shuffle" feature on your iPod nano,
iPod touch and iPhone before docking the device on the OnBeat Venue.
BLUETOOTH WIRELESS STREAMING
To wirelessly stream audio to the OnBeat Venue from a Bluetooth-enabled device:
1. If the OnBeat Venue's Bluetooth LED is not flashing blue, press the Source button until
the Bluetooth LED begins flashing blue.
2. Place the Bluetooth-capable device in the pairing mode. Use the device's Bluetooth
pairing menu to pair with OnBeat Venue. (If the device requires a pairing code, use
0000.)
3. When OnBeat Venue's Bluetooth LED illuminates blue continually, it is paired with the
device and you can stream audio via Bluetooth from the device to the OnBeat Venue.
To disconnect the Bluetooth device, press and hold the Source button. To pair OnBeat
Venue with a different Bluetooth-enabled device, repeat Steps 2 and 3 with the new device.
www.jbl.com
3