Battery Charger - Worx WA3868 Manual De Instrucciones

1. BATTERY PACK*
2. CHARGER
3. CHARGE INDICATOR LIGHT
* Not all the accessories illustrated or
described are included in standard delivery.
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the battery charger. Refer to the accessory
packaging for further details. Store personnel can
assist you and offer advice.
TECHNICAL DATA
Rated Input voltage
Output voltage
Charging current
Rated Input power
Charge battery
Charging time (approx.)
Protection class
Machine weight
WARNING: This product may contain lead,
phthalate or other chemicals known to the
State of California to cause cancer, birth defects and
other reproductive harm. Wash your hands after use.
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
WARNING: Changes or modifications to
this unit not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,

Battery Charger

if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
120V~60Hz
CHARGING PROCEDURE
20V
NOTE: Before using the tool, read the
instruction book carefully.
1.5A/2A
CHARGING INSTRUCTIONS
50W
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack
Li-Ion
are specifically designed to work together
so do not attempt to use any other devices. Never
45min (1.5A)
insert or allow metallic objects into your charger
1hr (2A)
or battery pack connections because an electrical
failure and hazard will occur.
/II
2. BEFORE USING YOUR CORDLESS TOOL
0.46kg
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger. The
LIGHT (3) will become green and flash to show
charging has started.
3) After charging approx 45min/1 hour, the light
will stay green without flashing, which means
the battery is full, and charging is completed.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
3
EN