Storage; Troubleshooting - Furrion FS22N20A-SS Manual De Instrucciones

3. Remove the LED assembly and disconnect the wire from
the base of the LED assembly. (Fig. 23)
Fig. 23

Troubleshooting

Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that
are not the result of defective workmanship or material in your appliance.
Problem
Ensure gas supply valve is open.
Burners do not light Burner ports or slots are clogged. With the burner off, use a small-gauge wire or needle to clean ports or slots.
Low gas supply level in cylinder.
Moisture is present on the burner, dry burner thoroughly.
Burner flame burns
half way around
Burner ports or slots are clogged. With the burner off, clean ports with a small-gauge wire or needle to clean ports or slots.
Dust particles in main line. Allow the burner to operate a few minutes until flame turns blue.
Burner flame is orange
In coastal areas, a slightly orange flame is unavoidable due to salt air.
11
4. Plug the wire harness connector into the new LED
assembly.
5. Reattach the LED assembly to the console with the
2 screws removed in step 3. Ensure the wires are not
pinched during this process.
6. Reattach the control knob by aligning the stem of the
control into the opening in the control knob housing and
pushing it back into position.

Storage

Dry all surfaces and burner box, then spray surfaces with
cooking oil substance to preserve the surface from rusting
during long term storage. Wipe off oil coating before reuse.
Possible Causes / Solution