Operation; Leak Check; Lighting Instructions; Shut Off Instructions - Furrion FS22N20A-SS Manual De Instrucciones

Check that the Connection Is Tight
When installation is completed, check the pipe fittings for
leaks using a gas leak detection solution. Never use a flame.

Leak Check

WARNING
FIRE OR EXPLOSION
● Extinguish all open flames.
● NEVER leak test when smoking. Never use a flame.
● Do not use the appliance until connection has been leak
tested and does not leak.
● Pressure/Leak test using 11-13.8 WC pressure.
WARNING
● Gas leaks may occur in your system and result in
a dangerous situation. Always perform a leak test
for possible leaks according to the manufacturer's
instructions after installation and before any operation.
● Gas leaks may not be detected by smell alone. Gas
suppliers recommend you purchase and install a UL
approved gas detector.

Operation

WARNING
Keep your arms and face away from being directly above
the cooking area while in operating the appliance.

Lighting Instructions

1. Before lighting, reset gas control knobs
to the OFF position.
2. Check that the main inlet gas valve is
OPEN.
3. Keep the oven door in the open position
for the full ignition process to view the
pilot and burner until lit.
4. Push and turn the gas control knob counterclockwise to
position until pilot lights. (You will hear a clicking sound
when the knob is pushed in.)
5. If ignition does not occur in 5 seconds, turn gas control
knob off, wait 5 minutes and repeat the lighting procedure.
6. Once the pilot flame is lit, continue to hold the oven
control knob in for 10-15 seconds, then release knob and
verify pilot stays lit. Repeat the above steps if pilot goes
out after releasing the knob. (Keep the oven door open for
this process)
7. After the pilot flame is ignited and the control knob is
released, then turn the control knob counter-clockwise to
the required temperature setting.
8. Verify visually that the oven burner has ignited once the
control knob has been set to the desired temperate. The
burner flame should ignite within a few seconds.
7
WARNING
● DO NOT use matches, candles or other sources of
ignition when checking for gas leaks.
● Do not smoke while leak testing.
● Never leak test with an open flame.
Please follow below steps to make leak test for the appliance:
1. Extinguish all open flames.
2. Turn the gas supply valve and control knobs off.
3. Prepare soap solution mixing of equal parts mild
detergent or liquid soap and water.
4. Spray the soap solution on all gas connections and gas
pipes of the appliance.
5. Turn the gas supply valve on and inspect all gas
connections for bubbles:
− If no bubbles appeared, there is no gas leak in the
appliance
− If bubbles appeared, where there are bubbles, where
there is a leak point.
6. If a gas leak is detected, tighten the connection and
repeat the above steps. If the leak is on the gas supply line
connection, replace the gas supply line and repeat above
steps.
NOTE: It is also recommended that you perform a leak test
at least once a year whether the propane gas supply cylinder
has been disconnected or not.
9. After verifying the burner has ignited, please close the
oven door to continue the preheat process.

Shut off Instructions

1. To extinguish the burner, push the oven control knob
and rotate clockwise to OFF position. Extinguish all pilot
flames when refueling or traveling.
2. Turn the main gas supply off.
3. Before transit, turn the main gas supply off at the shut off
valve.
4. The fan may continue to run for 10 - 15 minutes after
turning the oven off.

The Burner Flame

Flames should appear similar to the good flame shown in
diagram below. (Fig. 13)
Good
Yellow
Fig. 13
Bad
Blue
Yellow
Blue
Holes in Burner