Steam Cleaning + Injection Hot Water Or Detergent; Topping Up The Boiler Water Tank With Water - Lavor ETNA 3000 Manual De Usuario

Aparato polivalente para la limpieza a vapor. también puede usar el aparato como un simple aspirador de polvo y de líquidos
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
steamcleaning functions together.
-
To select the suction power (from level 1 to
level 4), press the remote suction button
L
on the handgrip at short intervals; the
1
selected suction power level LED indicator
will light up. It is possible to change the
power level both when the suction is on
and off . To switch the vacuum on and off ,
hold down the remote suction button L
for about two seconds.
-
When work is fi nished, release the steam
lever L
a few moments prior to switching
3
off the suction motor L
suction ducts to recover the humidity.
STEAM CLEANING + INJECTION HOT WATER
OR DETERGENT
B
E
• Fit the most suitable accessory in the handle
. This will allow the
1
P
F
W
L
1
L
1
L
3
of the fl exible hose L.
• Connect the device to a suitable electrical
outlet.
-
Start vacuuming by pressing main switch
B.
-
Turn on the steam system using switch
and wait until "steam ready" light D lights
up.
-
Start injection pump by pressing switch
1
-
Selection with switvh regulator
ter or detergent
-
To help the primer of the injection pump,
turn the steam tap F off and press the le-
ver L
3
-
Pre-select the amount of steam using
the knob F located on the appliance. The
gauge R indicates the pressure inside the
boiler.
-
To steam and vacuum simultaneously: it
is possible to use the above-mentioned
steamcleaning functions together.
-
To select the suction power (from level 1 to
level 4), press the remote suction button
L
on the handgrip at short intervals; the
1
selected suction power level LED indicator
will light up. It is possible to change the
power level both when the suction is on
and off . To switch the vacuum on and off ,
hold down the remote suction button L
for about two seconds.
-
When work is fi nished, release the steam
lever L
a few moments prior to switching
3
off the suction motor L
suction ducts to recover the humidity.
TOPPING UP THE BOILER WATER TANK WITH
WATER
• The boiler water tank L supplies the boiler
through an electronic level control; since this
is an external tank, it can be topped up any
time.
• When water runs out in the boiler water
tank:
1. the appliance beeps intermittently
EN
EN
E
P.
W hot wa-
1
. This will allow the
1
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ivp vac 3000

Tabla de contenido