COMO AUDIO The Turntable Manual De Usuario página 4

ASSEMBLY
EN
Platter, drive belt, and dust cover installation and stylus cover removal
With clean hands (finger oil could make the belt slip), install the flat drive drive belt as shown in
the above illustration, wrapping it around the exterior of the plastic sub-platter and the upper
section of the pulley. Do NOT place the belt over the lower section of the pulley. Place the black
metal platter over the sub-platter on the turntable and put the Como Audio felt mat on the top
of the metal platter to protect your records. Align the holes in the back of the dust cover over
the hinges on the back of the turntable's base and gently slide the dust cover over them.
Connect the included external power supply to the rear 15V/0.8A input.
> Remove the clear protective cap under the stylus prior to playing a record! Save the cap.
______________________________________________________________________________
Controls, Features, and Connections
1 ON/OFF POWER SWITCH (left side)
2 DRIVE PULLEY
3 PHONO/LINE OUTPUT, GROUND CONNECTION
4 BLUETOOTH POWER SWITCH (right side)
5 SPEED CONTROL BUTTON
6 POWER SUPPLY INPUT
Illustrations may vary.
4