COMO AUDIO The Turntable Manual De Usuario página 6

To restart the Turntable's Bluetooth transmitter, turn the Turntable's Bluetooth switch OFF and
EN
ON. A restart is usually only needed when pairing to a new device or if the Como Audio model has
been Factory reset.
When changing from Bluetooth to another source you may need to lower the volume, as
Bluetooth automatically requires and sets a higher volume level than other sources.
For your convenience, your Como Audio system allows you to save Bluetooth as a preset. Simply
press and hold one of the front panel preset buttons on your Como Audio model when in
Bluetooth mode. From then on, briefly press that preset button to go to Bluetooth mode even if
the Como Audio system is in standby.
We recommend leaving the Como Audio Turntable's Bluetooth switch on even when the Turntable
is not being used for faster connection when the Como Audio music system is placed in Bluetooth
mode.
It is normal to continue to hear a few seconds of sound through your Como Audio model after
lifting the tone arm on the record.
5. Playback speed button
To play records at 33 or 45 rpm, with the Como Audio Turntable on, briefly press the speed
control button in the lower left. The selected speed is shown respectively by the flashing green
LED. When the platter has attained full speed, the LED stops flashing. The default speed is always
33 rpm.
To play 78 rpm records you must change the stylus to the Ortofon OM78 (not included) and change
the belt to a rounded belt that goes around the lower pully section. Please contact your dealer or
Como Audio for more information.
Note: Like most high-performance turntables, the Como Audio Turntable is manual, meaning the
tone arm is manually placed on the record and when one side of a record is finished playing,
manually lift the tone arm up using the tone arm lift lever and place it in the tonearm rest.
6. Power input
Connect the included 15V external power supply to this rear input. Several different plugs are
included. Select the correct plug for your region, insert the plug's four tabs into the power supply,
and push down on the center of the plug while pushing the plug upwards to lock it into position.
Connecting the Como Audio Turntable to SpeakEasy via Bluetooth:
Switch the Como Audio Turntable's Bluetooth switch On (switch is located on right side
1.
of turntable).
Press and hold SpeakEasy's Bluetooth knob (last knob on right) for 4 seconds and
2.
release. You will hear a chime confirming connection.
SpeakEasy's lights might continue to flash blue for some time. This is normal. If the
3.
turntable doesn't pair and connect within a minute or so, switch the Turntable's
Bluetooth switch off and on again.
Whenever you change SpeakEasy from the turntable to a different source such as
4.
playing Internet radio or a music service, to go back to listening to the turntable, or if the
turntable won't connect, switch the turntable's Bluetooth switch Off and back On again
and repeat step 2 above.
6