Diamond AD2N/H2G-R2 Manual De Instrucciones página 9

ENGLISH
3. SETTING PARAMETERS (PJEZ VERSION)
GB
The operating parameters, modifiable using the keypad, are divided into two types: frequent (type F) and
configuration (type C). Access to the latter is protected by password (default= 22) to prevent accidental or
unauthorised modifications.
Accessing the type F parameters:

Press the
there are active alarms, mute the buzzer). The
display shows the parameter code 'PS'
(password);

use the
parameters. The LED corresponding to the
category of parameters will be on (see Table).

press
with the parameter;
Accessing the type C parameters:

Press the
there are active alarms, mute the buzzer), the
display shows the parameter code "PS"
(password);

press the
setting;

use the
numbers until displaying "22" (password to
access the parameters);

press the
password;

use the
parameters. The LED corresponding to the
category of parameters will be on (see Table)
Warnings :
if no button is pressed for 60 s, all the changes made to the parameters, temporarily saved in the RAM, will
be cancelled and the previous settings restored.
button for more than 3 s (if
and buttons to scroll the
to display the value associated
button for more than 3 s (if
button to access the password
and buttons to scroll the
button to confi rm the
and buttons to scroll the

increase or decrease the value using the
and button respectively;

press to temporarily save the new value
and display the parameter again;

repeat the procedure for any other parameters
that need to be modified;

press the button for more than 3 s to
permanently save the parameters and exit the
parameter setting procedure.

press to display the value associated
with the parameter;

increase or decrease the value using the
and button respectively;

press to temporarily save the new value
and display the parameter again;

repeat the procedure for any other parameters
that need to be modified;

press the button for more than 3 s to
permanently save the parameters and exit the
parameter setting procedure.
2