Publicidad
Idiomas disponibles
Idiomas disponibles
Locking Device Tightening Instruction
For racks with formed indents on swaged ends.
1
Ensure the knurled locking nut is wound fully back and is
in contact with the head of the locking device.
2
Tighten the locking device firmly and securely by hand
making sure that it is centrally located in the indented
groove on the swaged legs of the rack.
3
Turning the knurled locknut clockwise, tighten firmly by
hand. Using the key tighten an extra 2mm ( / " approx) of
circumference travel.
For racks without indents
1
Ensure the knurled locking nut is wound fully back and is
in contact with the head of the locking device.
2
Tighten the locking device by hand until it comes into
positive and firm contact with the rack.
3
Using the key, tighten a further 1.125 (1 / ) turns.
4
Turning the knurled locknut clockwise, tighten firmly by
hand. Using the key tighten an extra 2mm ( / " approx) of
circumference travel.
BEFORE USE
All fasteners and components must be checked for tightness and
security before each ride.
RECOMMENDATION
Any surfaces that could possibly come in contact with the pack(s)
should be covered with protective material such as abrasion resistant
film, to prevent marking or damage to the surface finish.
RIDING SOLO
When riding solo always have the pack facing forward with the load
over the pillion seat.
RIDING WITH A PILLION PASSENGER
When riding with a pillion passenger the pack must be fitted facing
rearwards.
WARNING -
The VENTURA Bike-Pack System was not
designed as a back rest and should not be
used as one by the pillion passenger.
SECURING PACK TO PACK-RACK
To secure the pack use the straps with the quick release clips and
attach around the horizontal rung on the Pack-Rack carrier. On
some models the quick release system is not available. In this
situation loop the shoulder straps around the rung and fasten to the
buckle.
PACKING THE PACK
Always place heavy items at the bottom of the pack and load evenly.
Do not position sharp objects against the fabric of the pack.
MAXIMUM CARRYING CAPACITY
Unless specified to the contrary in the fitting instructions or the
motorcycle manufacturers recommendations/specifications the
recommended maximum load capacity of this system is 9kg (20lbs).
It is important that the pack is always securely fastened to the Pack-
Rack.
MAXIMUM SPEED
The maximum recommended speed that this system can be used is
130 kph (80mph) or the legal speed limit, whichever is the lower.
This limit may be reduced by other accessories, worn tyres,
improper handling, overall motorcycle condition or weather conditions.
REMEMBER
Exceeding the weight capacity or the recommended maximum speed
may drastically affect the motorcycles handling, stability and
performance.
L-BRACKETS
The L-Brackets must always have the Pack-Rack, Sport-Rack or
Grab-Handle fitted.
Y062B.e,s : Issue 1 : March 2001
IMPORTANT
The VENTURA BIKE-PACK SYSTEM is designed as a complete
unit. The use of non VENTURA parts, bags or other attachments will
render the warranty void.
The following VENTURA accessories are available for these/this
model motorcycle(s):
1
8
NOTE: Some jurisdictions do not allow limitations on how long
an implied warranty, if any, lasts, and do not allow the
exclusion of limitation of incidental or consequential damages
so the limitations and exclusions below may not apply to you.
This warranty gives specific legal rights, you may have other
rights which vary from jurisdiction to jurisdiction.
Dold Industries Limited ("Dold") warrants this product to be free from
1
defects in materials and workmanship under normal use and
8
maintenance for a period of one year from its date of original
purchase. Dold shall, at its option, either repair or replace a defective
1
product returned to it or its authorised agents, freight prepaid.
8
This warranty does not apply to any product which has been
altered,
improper installation or maintenance, abnormal wear and
tear due to exposure to the elements, negligence, abuse,
accidents or any like circumstance.
Dold shall not be liable for any incidental nor consequential
loss or damage resulting directly or indirectly from any
defective product, its sole obligation being to repair or replace
such defective product.
This warranty is in lieu of, and excludes, all other warranties,
expressed or implied, including the warranties of merchantability and
of fitness for a particular purpose.
To make a warranty claim return the product to the dealer who
supplied it with evidence of date of purchase. If you are not satisfied
with their response, please contact the distributors for your country
or: Dold Industries Ltd, 17 Perclo Place,
P O Box 10-393, Te Rapa, Hamilton, New Zealand.
Telephone +64 (7) 849-4392. Facsimile +64 (7) 849-4114.
E-mail: dold@ventura-bike.com. Internet: www.ventura-bike.com
VENTURA Light-Guard :
"Happy and Safe Motorcycling"
LIMITED WARRANTY
damaged
or
rendered
VP101
non-functional
through
E & O E
Page 2 of 4
Publicidad
