Maintenance - Maytag SkyBox MBV1976AA Manual Del Usuario

Maintenance

Cleaning
To avoid electrical shock, which can cause severe
personal injury or death, unplug the refrigerated
personal beverage vendor unit before cleaning.
The modular design of your SkyBox™ personal
beverage vendor allows for easy cleaning. Most spills
can be cleaned up with a damp cloth or sponge. If
using a household cleaner, choose a mild, non-
abrasive cleaner that will not scratch or dull the
surface of your unit. Do not allow beverage spills to
stand; clean up right away.
To avoid spills, do not store previously opened or
partially consumed bottles/cans in the SkyBox™
personal beverage vendor.
Removing The Door
1. Make sure the main unit is OFF and the power
cord is unplugged.
2. Unplug the door wire harness from the lower right
corner of the door and the lower left corner of the
personal beverage vendor.
3. Open the door wider than a 90° angle.
4. Lift the door up, releasing the door hinges from the
hinge posts.
Clearing Jams
If a jam occurs, the low-indicator lights will flash to
indicate the problem. If a single light is flashing, this
indicates that the jam is located within the corres-
ponding storage bin. If all lights are flashing, this
indicates the jam is most likely located in the dispens-
ing pathway. Most jams result from improper loading,
so please refer to pages 10-11 for proper loading
instructions.
To clear a jam open the SkyBox™ personal beverage
vendor door and inspect the dispensing pathway and
the storage bins. Remove or readjust the location of
the beverage containers.
Opening the door to clear the jam will eliminate the
blinking lights.
13
WARNING
Consider the following checklist.
• Have you loaded the beverage containers on their
sides all the way to the back with the tops facing
forward?
• Are your beverage containers no more than 3" in
diameter?
• Are you using cans or bottles of odd shapes or
sizes? If so, loading your SkyBox™ personal beverage
vendor with a single row of that product may help to
reduce jams.
• Is your personal beverage vendor crowded beyond its
capacity?
• Has the personal beverage vendor fully cooled
down? Some jams are more likely to occur when the
vendor is first plugged in and has not fully cooled.
Replacing Display Panel Light
Bulbs
1. Make sure SkyBox™ personal beverage vendor is
OFF and the power cord is unplugged.
2. Flip up the graphic access cover, exposing a screw
and the top edge of the front display panel.
3. Remove the screw.
4. Slide the front display graphic up and out of the
personal beverage vendor.
5. Lift the clear panel up and out of the unit, exposing
the sockets for the light bulbs.
6. Remove bulbs by rotating the bulbs toward you.
7. Install new 18" fluorescent bulbs type F15T8, 15
watt by sliding them into the light sockets and
rotating the bulbs away from you until they click
into place.
8. Replace the clear panel and slide the front display
graphic back into place in front of the clear panel,
behind the lower edge of the frame opening.
9. Reinsert the screw.
10. Flip the graphic access cover back down into place.