Maytag SkyBox MBV1976AA Manual Del Usuario página 7

Assembly
STEP 4 – Assemble Exterior Panels
E
F
• Lower the top lip of the left side panel (F) over the
top of end frame, aligning screw holes in side panel
with holes in the corner post. Make sure panel is
positioned to accommodate hinges for door on front
left side. Attach panel by installing three pan-head
screws (E) down the front of the unit and two pan-
head screws (E) along the top rail.
• Position the right side panel (G) over frame of
cabinet, aligning screw holes in side panel with holes
in corner post. Attach panel by installing
three pan-head screws (E) down the front of each
side panel and two pan-head screws (E) along the
top rail.
F
E
• Place back panel (H) over frame and side panels by
aligning screw holes on the back of the unit. Attach
back panel using six pan-head screws (E). During
this process, the screws will also secure the back of
the left and right side panels.
G
E
E
G
H
STEP 5 – Attach Door to
SkyBase™ Stand
F
N/J
• Position door (I) on the front of the stand by aligning
screw holes in the hinges (J) with hinge holes in the
left side panel on the front of the stand.
• Attach door hinges (J) to the left side panel (F)
using three flat-head screws (N) in each hinge.
I
6