Guide To The Inside Parts - Hotpoint Ariston MSZ 902 NDF/HA Guia Del Usuario

Guide to the inside parts

Removing and repositioning the refrigerator
compartment and freezer shelves.
The shelves can be positioned as required. The glass
shelves are strong enough to hold bottles, milk cartons
and heavy food, however, take care not to bang
products on the shelves. To remove the shelves: pull
the shelf out as far as it goes, then lift and remove it.
Removing the crisper or meat drawer:
1. slide the drawer out as far as it goes;
2. with one hand underneath the drawer, lift and pull it
out;
3. the drawer will come off the runners and can be
pulled out further;
4. to remove it completely, the drawer must be turned:
front end up, rear end down.
Removing and refitting the glass drawer lid.
Lift the front of the frame about 10 cm with one hand,
then lift the back of the frame and pull it out with the
other.
To replace the lid follow the inverse procedure.
Note: To remove the drawers and lids in the freezer
compartment follow the same procedure as for the
refrigerator.
Meat/vegetable drawer temperature control device.
The air flow can be adjusted by means of the
special slider.
To store vegetables in the meat drawer, shift the
•
control device all the way to the left, to the
vegetables setting. This avoids possible damage
due to the vegetables freezing.
Crisper moisture control device.
By moving the slider to the far left, humidity is
•
maintained inside the compartment. This setting is
better for preserving leaf vegetables.
The cold air is
•
conveyed inside the
meat drawer through an
opening between the
refrigerator
compartment and the
freezer compartment. In
this way the temperature
inside the meat drawer
is kept lower than the
rest of the refrigerator.
The level of humidity
•
inside the crisper can
be adjusted by moving
the slider in the desired
position.
By moving the slider
•
to the far right, humidity
will be eliminated from
the compartment. This
setting is better for
preserving fruits and
vegetables with skin.
27
EN