Turntable / Turntable Support; Grease Filters - Furrion FMCM17-BL Manual De Instrucciones

Care and Maintenance
performance. Carefully wipe with a damp
cloth any food spatters from the surface of
the cover immediately after they occur. Built-
up splashes may overheat and cause smoke
or possibly catch fire.
DO NOT REMOVE THE WAVEGUIDE COVER.
Vent Fan
The vent will automatically start when heat
rises from range surface units or burners.
This protects the microwave oven from
excessive temperature rise. The vent fan will
stay on until the temperature decreases. It
cannot be turned off manually during this
time.
Wipe the inside
Dampen a paper towel, microfiber cloth, or
similar material. Use this to scrub the inside
of your microwave, as well as the inside of
the door. Repeat as necessary if you need
more than one towel or cloth.

Turntable / Turntable Support

The turntable and turntable support can be
removed for easy cleaning. Wash them in
mild, sudsy water; for stubborn stains use
a mild cleanser and non-abrasive scouring
sponge as described above. They are
also dishwasher-proof. Use upper rack of
dishwasher. The turntable motor shaft is not
sealed, so excess water or spills should be
wiped up immediately.

Grease Filters

Filters should be cleaned at least once a
month. Never operate the vent fan or oven
without the filters in place.
Pull down slightly on the tab toward the front
of the oven and remove the filter. Repeat for
the other filter.
Soak the filter in a sink or dish pan filled
with hot water and detergent. DO NOT use
ammonia or other alkali; they will react with
the filter material and darken it.
Agitate and scrub with a brush to remove
embedded dirt.
Rinse thoroughly and shake dry.
Replace by fitting the filter back into the
opening.
Grease Filter
Light
To replace light bulbs:
1. Disconnect power to the oven at the
circuit breaker panel or unplugging.
2. Remove the screws from the light cover.
(See illustration)
3. Replace the bulb with 120V, 20W x 2,
type: T22. (See illustration)
Close light cover and secure with screw
removed in step 2.
CAUTION
Light cover may become very hot. Do not
touch glass when light is on.
Light Cover
Incandescent Bulb 120V 20W x 2, type: T22
Screw
22