Publicidad
Idiomas disponibles
Idiomas disponibles
Activate the glass panel lifting up, as shown in
the 'Working' section; when the panel is comple-
tely open, which is done by setting the IV speed,
remove the grid as shown in (fig. 8), then remove
the grease filters and make sure the hood is se-
curely fixed to the wall, by using the inside screws
(fig. 9).
Reinsert the grease filters, the grid and close the
front panel by setting the OFF function, as shown
in the 'Working' section.
Sucking version – upper outlet
Fix the pipe bearing bracket to the wall and/or
ceiling by using the anchor screws and screws
provided (fig. 10), centred to the hood.
Connect the motor air-outlet flange to the exhaust
hole, by using a suitable pipe.
Place the two ornamental pipes on the hood
body; lift the internal pipe up until it reaches the
ceiling; then fix it to the pipe bearing bracket, by
using the two self-threaded screws provided.
Sucking version - back outlet
Install the air outlet grill above the hood in the
relative seat (refer to Fig. 10). The stainless steel
chimneys are not necessary.
Filtering version
Install the air outlet grill above the hood in the
relative seat (refer to Fig. 10). The stainless steel
chimneys are not necessary.
In case that the appliance is used in the filtering
version mode, it is necessary to install the char-
coal filters. First remove the metal grease-filter,
as indicated for each model in the MAINTENAN-
CE part, then place the charcoal filter in his seat
just behind the grease-filter.
WORKING
(fig. 12)
A : ON/OFF lights
B : speed reduction / OFF motor
C : speed indicators
D : ON motor/speed increase
E : 10 min timer.
The Touch control panel on the glass allows you
to set the function desired by lightly touching the
corresponding key.
If the electrical power supply to the model is cut,
15 seconds are needed for self-diagnostic after its
functions are restored. In the meanwhile, its ope-
ration may be incorrect.
The FCLHD model, in addition to the
working features described in the paragraph
above, has an automatic opening and closing
system of the glass panel.
The opening of the glass panel corresponds to
and varies according to the motor speed set.
The panel is closed automatically, after the motor
is switched off.
A safety device reverses the panel direction in
case of impact with unusual surfaces during its
normal travel.
All of the appliances are equipped with an elec-
tronic device allowing for automatic switching off
after four hour working from the last operation
performed.
The electric red button on the upper side of the
hood allows to reset the appliance when there is
an operation anomaly.
Press the red button to power off the hood and
then press again the red button to restore power
on.
16
Publicidad
