English - Braun Exact Power EP 50 Manual De Usuario

English

Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Warning
• Keep the appliance dry.
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace it
if necessary.
Description
1a Small distance comb (trimming
beard and short hair)
1b Large distance comb (cutting hair)
2 Cutter system
a beard trimming/hair trimming
b release buttons
Technical specifications
Power supply: 100 – 240 V
Wattage:
Charging your beard trimmer for cordless operation
• Connect the trimmer to the mains with the on/off switch on position «0»
and charge it for at least 8 hours. The pilot light indicates that the trimmer
is connected to the mains.
• Once the trimmer is completely charged, use it without the cord until
discharged.
• Then recharge to full capacity again (subsequent charges will take about
8 hours).
• A full charge will give up to 30 minutes of cordless trimming depending
on your beard. However, the maximum capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for charging is 15 °C to 35 °C.
• If the rechargeable battery is discharged, you may also operate the
trimmer via the mains cord. (If the trimmer does not run immediately,
charge it for approx. 1 minute.)
2
(automatic adaptation)
5
3 Speed selector
4 On/off switch
with beard length selector
5 Memory switch
(for 6 beard length settings)
6 Pilot light
/ 50 or 60 Hz
7