Statement Of Use; General Safety Instructions - Atlas Copco MT Focus 6000 Manual Del Usuario

Safety Information
Safety
WARNING Risk of Property Damage or Se-
vere Injury
Ensure that you read, understand and follow all
instructions before operating the tool. Failure to
follow all the instructions may result in electric
shock, fire, property damage and/or severe bod-
ily injury.
Read all Safety Information delivered to-
►
gether with the different parts of the system.
Read all Product Instructions for installa-
►
tion, operation and maintenance of the dif-
ferent parts of the system.
Read all locally legislated safety regulations
►
regarding the system and parts thereof.
Save all Safety Information and instructions
►
for future reference.

Statement of use

This product is intended to be used to monitor and
control tools. No other use permitted.
EMC RESTRICTION OF USE: FOR INDUS-
TRIAL USE ONLY.
Product specific instructions
Storage and transport
• The components should be stored at a dry
place, and should be protected from dust and
aggressive media. High variation of tempera-
ture should be avoided.
• Each connection should be removed before
transport to avoid breaking the connecting ca-
bles.
Use sufficient insulation of the shipping packet
to protect components against damage.
Installation safety
• Refer installation to qualified personnel only.
• Always connect the system to an earthed outlet.
• Always make sure that the mains plug is dis-
connected and the controller is turned off be-
fore connecting or disconnecting the tool cable.
Operation safety
• This product shall only be operated indoors in
dry rooms.
4 © Atlas Copco Industrial Technique AB - 9834 3579 00
• This product must not be used in explosive at-
mospheres.
• The product must only be operated by a quali-
fied person in an industrial assembly environ-
ment. Make sure that the tool bit does not come
in contact with the conductors in the controller
cord, or any other concealed conductors or live
electrical parts.
• The tool is intended for intermittent use. A typ-
ical operating cycle is 1 s on, 4 s off. This may
vary substantially depending on the applica-
tion. The acceptable duty cycle depends on
many factors including torque and joint type.
The tool contains protective mechanisms that
ensure that the acceptable duty cycle is not ex-
ceeded.
Maintenance safety
• Cleaning of the components and the connecting
cables should not be done with solvent contain-
ing cleanser.
• Trouble-shooting and re-start of the system
may only be carried out by an authorized per-
son.
• Refer servicing to qualified personnel only.

General Safety Instructions

WARNING Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future
reference.
To reduce risk of injury, everyone using, installing,
repairing, maintaining, changing accessories on, or
working near this tool must read and understand
these instructions before performing any such task.
When using electric equipment, basic safety pre-
cautions, including the following, should always
be followed to reduce the risk of fire, electric
shock and personal injury.
Our goal is to produce equipment that help you
work safely and efficiently. The most important
safety device for this or any equipment is YOU.
Your care and good judgement are the best protec-
tion against injury. All possible hazards cannot be
covered here, but we have tried to highlight some
of the important ones.
MT Focus 6000