Panel Description - Iso-Tech ILCM 03A Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2. Panel Description

1.Transformer Jaw
This is used to pick up current signal.
conductor must be enclosed by the jaw.
2.Transformer Trigger
This is used to open the jaw.
3.Function Selector Switch
This is used to select the function user desired, such as ACV, ACA, Ohm
and Continuity.
4.Frequency Selection Switch
At 50/60Hz position, only the low frequency signal is measured. At Wide
position, signal from 40 - 1KHz is measured.
5.Data Hold Button
Once this button is pushed, reading shall be held on the LCD. Press again
to release it.
This button is not available in continuity function.
6.Max/Min Hold Button
This button is used to enable the maximum or minimum value to be
displayed and updated during measurement.
value shall be displayed and updated.
shall be displayed and updated.
disabled if Max/Min function is enabled. This button is not available in
continuity function.
7.Zero/Relative Button
Once this button is pressed, the current reading shall be set to zero and
be used as a zero reference value for all other subsequent measurement.
This function will be disabled when MAX/MIN function is enabled.
button is not available in continuity function.
To measure DC/AC current,
Press once, minimum
Press again, maximum value
The Zero/Relative function will be
2
This

Publicidad

Tabla de contenido
loading

Productos relacionados para Iso-Tech ILCM 03A

Tabla de contenido