EN
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Mounting
Diagram
Control Panel
Description
Password
The COLORado™ 4 IP will work with a DMX controller using a regular
DMX
serial
connection.
www.chauvetpro.com.
The COLORado™ 4 IP uses a regular DMX data connection for its DMX
personalities: TOUR, TR16, ARC.1, AR1.D, ARC.2, AR2.D, AR2.S,
HALO, PIX1, PIX2, and HSV. See the User Manual to connect and
configure for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the TR16
personality, be sure that both dimming curves in SET > DIMX and
SET > CURV are set to OFF.
The COLORado™ 4 IP uses the DMX data connection for its Master/Slave
mode. See the User Manual to connect and configure for Master/Slave
operation.
Overhead Mounting
Button
<MENU>
Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases
<DOWN>
the numeric value when in a function
After being prompted, enter the following password by pressing:
<UP>, <DOWN>, <UP>, <DOWN>, <ENTER>
This password cannot be changed and must be used whenever prompted.
A
DMX
Secure the safety cable using
the passageway on the back
of the product.
Function
3
COLORado™ 4 IP QRG
Primer
is
available
Floor Mounting
from