Electrical Safety - Diamant Boart FORASPIR 2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
This symbol indicates that the
machine is in conformance with
the applicable European directive.
PREFACE
Before leaving our factory, all pumps under-
go a series of tests in which everything is
stringently checked.
By following our instructions carefully you
should obtain many years of service, under
normal working conditions.
The advice on use and spares given in this
document is for information only, and is not
contractual. No guarantee is made against
errors or omissions, or against damage rela-
ting to the design, delivery or use of the
pump. We are continually seeking to impro-
ve the quality of our products, and reserve
the right to make technical changes to them
at any time without notice.
This document should help the user to:
• become familiar with the pump,
• learn how it can be used,
• avoid accidents arising from inappro-
priate use, maintenance, repair or
transport by untrained staff,
• increase the pump's reliability and
endurance,
• ensure that it is used correctly, regu-
larly maintained and quickly repaired,
reducing repair costs and down-time.
1
Technical specifications
• Power : 0,18 Kw.
• Speed : 2800 rpm.
• Voltage : 230 V.
• Frequency : 50 Hz.
• Noise : 54 Dba.
• Fuel capacity : 10 litres
• Output : 50 litres/min
• Suction : 0,9 bar.
• Weight : 14 kg.
2
Electrical connection

- ELECTRICAL SAFETY :

Operate this machine only on a
supply equipped with a 30 mA ear-
thed current-limiting circuit-brea-
ker. Otherwise, consult our cata-
logue for appropriate models.
- The RCCB must be used cor-
rectly, including testing it regu-
larly. For tools supplied with an
integral RCCB in the cable or in
the mains plug, if the cable or
plug
has
been
repairs must be carried out by
the manufacturer, one of his
agents or by a qualified repair
workshop to avoid any risks
resulting from errors.
• Make sure your mains voltage
=
matches the one given on the
?
pump's identification plate
• Only use single-phase earthed
three-pin plugs
• Use the appropriate mains cable:
single-phase 3x1 mm
• If using an extension cable, make
sure it is thick enough for the cur-
rent. Up to 50 metres: 1.5 mm
Above that, double the section.
• If plugging into a temporary mains
board, make sure it has a 30 mA
earth leakage circuit breaker.
Place the machine on a dry surfa-
ce or dry ground
• If the motor will not start when set to 1
(Start), then:
Check the power supply to the site
n
(fuses, cut-out switch)
Check the extension lead (wrongly
n
connected, faulty wire)
Check the cable is properly plugged in
n
Check the on-off switch
n
Before checking the machine,
unplug it from the supply.
3
Starting
• When setting up, follow the instructions for
use and protection
• Plug in the pump and connect it to the
accessory
• Once started, the vacuum gauge will
register -0.9 bar very quickly.
4
Maintenance
• Check the condition of the filter very regu-
larly. It should not contain dust or water.
If it does, clean it:
Unscrew the carboy and remove the filter
n
Clean them both and reassemble
n
• Check that there is no water in the tank :
Open the drain plug
n
Drain off any water
n
damaged,
Tighten the plug again
n
5
Repairs
To have repairs done cheaply and
S
quickly, consult your supplier.
A
V
2
2
.
6
Pièces de rechange
For fast delivery of spares and to save time,
remind your supplier each time of the type
of pump, the year you bought it, and the
reference of the replacement part.
00000000
Item numberCode
See exploded view
7
Scrapping
In the event of deterioration and
scrapping of the machine, the fol-
lowing items must be disposed
of in accordance with the requi-
rements of the legislation in
force.
• Main materials :
Motor : Aluminium (AL) - Steel (AC),
n
Copper (CU) - Polyamide (PA)
Machine : Steel sheet (AC) - Stainless
n
The instructions for use and spare parts found in
this document are for information only and are not
binding.
As part of our product quality improvement policy,
we reserve the right to make any and all technical
modifications without prior notice.
(0)
Quantity
steel.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido