Features
Front Panel
2
5
INPUT LEVEL
OUTPUT LEVEL
IN / OUT LEVEL
-18 -12 -6
0
+12
CLIP
-18 -12 -6
0
+12
CLIP
-18 -12 -6
0
+12
CLIP
(dB)
(dB)
(dB)
SPLITTER
MIXER
CH 1
MAIN
LINK
3
SPLITTER
MAIN IN
MAIN OUT
LEVEL
MIXER
1
4
1.
Main Input Level Control: Use this knob to adjust the level of the Main Input signal.
2.
Input Level Meter: This LED meter shows the level of the Main Input signal. If the Clip
LED illuminates, turn down the Main Input to prevent the signal from distorting.
2
3.
Main Link Control: Press this switch to send the Main Input signal to the Main Output.
Main Output Level Control: Use this knob to adjust the level of the Main Output signal.
4.
Output Level Meter: This LED meter shows the level of the Main Output signal. If the
5.
1
Clip LED illuminates, turn down the signal at either the input stage or the Main Output to
avoid distorting the signal.
Split/Mix: Use this switch to select the mode for each mono channel. For Splitter mode,
6.
disengage the switch, and the Main Input signal will be
output.
For Mixer mode, engage this switch, and the mono channel input signal will be
sent to the Main Output bus. This signal will combine with the main input signal when the
Main Link is activated. You can also route the mono channel input signal to the mono
channel output directly.
7.
Channel
Level Control: Use this knob to adjust the level of each mono channel. In
Splitter mode, this adjusts the output level of each individual mono channel. When in
Mixer mode, this adjusts how much of the mono channel input signal is sent to the Main
Output and/or each individual mono channel output.
8.
Input/Output Level Meter: This LED meter shows the output level of each mono
channel.
If the Clip LED illuminates, turn down the Main Input Level Control to prevent the
signal from distorting.
Balance/Pan Control: If the stereo main signal is split into the mono channel output, or
9.
the mono input signal is routed to the stereo main output bus, use this knob to determine
the proportion between the left and the right channel.
10. Power Switch: Use this switch to turn the unit on or off.
11. Power LED: This LED will light up when the unit is powered on.
IN / OUT LEVEL
IN / OUT LEVEL
-18 -12 -6
0
+12
CLIP
-18 -12 -6
0
+12
CLIP
-18 -12 -6
(dB)
(dB)
0
0
0
CH 2
CH 3
L
R
L
R
L
R
SPLITTER
SPLITTER
BAL /PAN
BAL /PAN
BAL /PAN
LEVEL
LEVEL
LEVEL
MIXER
MIXER
8
IN / OUT LEVEL
IN / OUT LEVEL
IN /OUT LEVEL
0
+12
CLIP
-18 -12 -6
0
+12
CLIP
-18 -12 -6
0
+12
CLIP
(dB)
(dB)
(dB)
0
0
CH 4
CH 5
CH 6
L
R
L
R
L
SPLITTER
SPLITTER
SPLITTER
BAL /PAN
BAL/PAN
BAL /PAN
LEVEL
LEVEL
MIXER
MIXER
MIXER
7 6 9
6
5
4
split and routed to this channel
11
11
POWER
0
ON
SPLIT MIX 6
OFF
R
10
10
3
3