Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2
5
3
1
4
Rear Panel
2
AC INPUT: 100 -240V~ 50/60Hz
FUSE: T500mAL AC 250V
RATED POWER CONSUMPTION: 15W
OUT
IN
OUT
1
CH 6
CH 5
1.
Fuse Holder:
Check what the available voltage is in your country and confirm the voltage
switch for Split Mix 6 is configured correctly before connecting the power cable to Split
Mix 6.
Caution: The fuse should only be changed by a qualified technician. If the fuse continues
to blow after replacing, discontinue use of Split Mix 6 until it is repaired.
2.
Power Connector: Connect the included power cable here.
Note: Do not connect the power cable to Split Mix 6 until the voltage has been correctly
set.
3.
Main Inputs: These two balanced XLR connectors are used to input the main stereo
signal. In Splitter mode, these can be sent to each mono channel output.
Main Outputs: These two balanced XLR connectors are used to output the main stereo
4.
signal. By engaging the Main Link switch, the signal will be sent to the Main Input.
5.
Mono Channel Inputs: For channels 1-4, use the XLR balanced connectors to input the
mono signal. For channels 5-6, use the TRS connectors.
Mono Channel Outputs: For channels 1-4, use the XLR balanced connectors to output
6.
the mono signal. For channels 5-6, use the TRS connectors.
4
0
IN
OUT
IN
OUT
IN
OUT
CH 4
CH 3
8
0
7 6 9
IN
OUT
IN
R
L
CH 2
CH 1
MAIN OUT
5
4
6
11
10
R
L
MAIN IN
3
Publicidad
Tabla de contenido
