Troubleshooting; Product Maintenance - HAMPTON BAY 480-997 Manual De Instrucciones

INSTALLATION:
#4 Mounting Strap

TROUBLESHOOTING:

Problem
Light Bulb will not illuminate.
Fuse blows or circuit breaker trips
when light bulb is illuminated.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the
glass and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the
fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside
glass and interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years
from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and
service. If this product is found to be defective, the manufacturer's only obligation, and your exclusive remedy, is the repair or
replacement of the product at the manufacturer's discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been
improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product. This warranty
shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or
any other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the
product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained
herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or
damage, including but not limited to any labor / expense costs involved in the replacement or repair of said product.
#1 Outlet Box
Smooth Fixture
Wire to Black
Supply Wire
#3 Ground Wire
#5 Ground Screw
Outlet Box Screw
Fixture Wire
#11 Canopy
#13 Loop Ring
Possible Cause
1. Light bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire is grounding
out.
LIMITED WARRANTY
Ribbed Fixture Wire to
White Neutral Wire
#7 Hex Nut
Threaded Nipple top
#9 Threaded Nipple
Outlet Box Screw
#15 Chain
Corrective Action
1. Replace light bulb.
2. Make sure power supply is on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.
4