HAMPTON BAY 43058 Guia De Inicio Rapido

TOOLS REQUIRED
Phillips
Electric drill
screwdriver
Installation
1
Wood post/fence mounting
□
To mount the solar light to a wood post or fence, measure
and mark on the wood surface at the locations of both
mounting screws 2 in. on-center.
□
Insert the mounting screws (AA) into the wood post or fence
at the marked locations, leaving about 1/4 in. of the screws
(AA) sticking out of the wood surface.
□
Align and place the two mounting holes on the back plate of
the solar light over the mounting screws (AA).
IMPORTANT: Prior to use, pull out the top cap (A) from the
lamp housing (B). Then, remove the battery isolator tag (C)
inserted in the battery compartment. Replace the top cap
back to the lamp housing and allow it to charge a full sunny
day.
IMPORTANT: Ensure the mounting location for your solar
light allows the solar panel to receive direct sunlight. Do
not locate the product in shaded areas as this will
significantly reduce performance.
NOTE: The solar light is equipped with a photosensor that
turns the unit on at dusk and off at dawn. Ambient light can
affect the operation of the photosensor.
1 2
A
C
B
Safety Information
WARNING: Your solar light may not function in temperatures
below -4º F (-20º C) or above 140º F (60º C).
CAUTION: Use a rechargeable battery only. Recycle or
dispose of batteries properly.
CAUTION: Do not open, short circuit, or mutilate batteries as
injury may occur.
SOLAR DECK LIGHT
ITEM # 100000000
MODEL # 43058
3 4
AA
HARDWARE INCLUDED
AA - Wood Screw x 2 BB - Plastic Anchor x 2
2
Wall mounting
□
To mount the solar light to a concrete wall, measure and
mark on the wall at the locations of both mounting screws 2
in. on-center.
□
Drill two holes on the wall at the marked locations.
□
Insert the plastic anchors (BB) into the holes. Insert the
mounting screws (AA) into the anchors (BB), leaving about
1/4 in. of the screws (AA) sticking out of the wall surface.
□
Align and place the two mounting holes on the back plate of
the solar light over the mounting screws (AA).
IIMPORTANT: Prior to use, pull out the top cap (A) from the
lamp housing (B). Then, remove the battery isolator tag (C)
inserted in the battery compartment. Replace the top cap
back to the lamp housing and allow it to charge a full sunny
day.
IMPORTANT: Ensure the mounting location for your solar
light allows the solar panel to receive direct sunlight. Do not
locate the product in shaded areas as this will significantly
reduce performance.
NOTE: The solar light is equipped with a photosensor that
turns the unit on at dusk and off at dawn. Ambient light can
affect the operation of the photosensor.
1 2
A
C
B
Please contact 1-855-HD-HAMPTON for further assistance.
Use and Care
Guide
3 4
AA
HAMPTONBAY.COM