Axis Q60 Serie Guia De Instalacion página 23

10. Slide the unit holders on the network camera into the slots in the mounting plate and
rotate the camera unit.
11. Install the supplied midspan. See page 25.
12. Install the ceiling tile with the camera mounted on it.
13. Put the trim ring on the ceiling bracket and tighten the screws.
1 Trim ring
2
Trim ring screw T20 (4x)
Install the Camera on a Bracket Mount (sold separately)
1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws and plugs that are appropriate for
the material.
2. Loosen the camera base lid screws and remove the camera base lid.
3. Route the network cable and the multi-connector cable, if applicable, through the holes
in the mounting bracket.
4. Secure the camera using the supplied safety wire.
AXIS Q60 Series
23
1
2