Kalorik WCL 42513 Manual De Instrucciones página 7

Fax +32 2 359 95 50
CAUTION: The 2-in-1 mini-refrigerator and wine cooler should not be
built-in. Standalone use only!
OPERATION
CAUTION: Before connecting the appliance to electrical power
supply, leave it to stand for about 4 hours, which will reduce the
possibility of malfunctions in the cooling system due to transport
handling.
Before use, clean the appliance thoroughly; especially in the
•
interior (See Cleaning and Maintenance).
Rearrange the shelves in the cavity properly if they are not
•
correctly placed.
Make sure that your mains voltage corresponds to that stated on
•
the appliance.
Position the appliance in a cool place, on a stable surface near a
•
wall outlet, with sufficient clearance on all sides to allow proper
ventilation. Do not attempt to install the appliance into a built-in
unit!
Plug in the appliance to an earthed wall outlet.
•
Once connected to a power source, the fans will start turning
•
and the wine cooler will start cooling. The cooler will need up to
one and a half hours to reach 15°C/ 60°F and up to 4 hours to
reach the temperature set up as the factory standard.
NOTE: The inside temperature of the thermoelectric 2-in-1 mini-
refrigerator and wine cooler depends on the room temperature. To
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity. Print only what is inside the frame.
7
Back cover page (last page)
Assembly page 7/36
WCL 42513 - 120501