Fax +32 2 359 95 50
4) Upper zone and bottom zone are each controlled separately.
Press "SET" once to control the upper zone (the upper display will
flicker). Press "SET" twice to control the lower zone (the lower
display will flicker).
5) Once the desired zone is selected, use the + (up) and – (down)
buttons to adjust the temperature up or down.
6) When the power switch is connected, cooling system starts to
work. The temperature is set on certain temperature level, which
means that when the inner temperature reaches the set point,
the appliance will stop cooling, so that the temperature in the
cabinet rises gradually.
7) When the inside temperature rises above the set point, cooling
will resume until reaching this set point, the cellar enters into
cooling cycles.
You can turn the interior light ON or OFF by pressing shortly the light
switch on the control panel. The light will also turn off automatically
after 10 minutes.
Note:
This 2-in-1 mini-refrigerator and wine cooler needs to be
•
placed on a flat floor, with 12cm /5in. space on each side;
and 12cm / 5 in. space at the backside. This appliance is not
designed to be built-in.
Make sure to place the cooler perfectly level for best function.
•
Avoid placing in direct sunshine or near a heating source, or in
•
an unventilated area.
Do not place heavy items on top of the appliance
•
CLEANING
Unplug the appliance from the wall outlet before cleaning it.
•
Clean the exterior of the appliance with water and a mild
•
household detergent. Do not use abrasive cleaners as they can
damage the finish of the appliance. Rinse well and wipe dry with
a clean soft cloth.
Clean the interior of the appliance with lukewarm water and
•
baking soda. The solution should be about 2 tablespoons of
baking soda to 4 cups of water.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
9
Back cover page (last page)
Assembly page 9/36
WCL 42513 - 120501