Mounting; Connection - Resol AM1 Instrucciones

AM1 alarm module

1. Mounting

upper part of the housing

2. Connection

terminals of the AM1
10
|
base part of the housing
ATTENTION! ESD damage!
Electrostatic discharge can lead to da-
mage to electronic components!
Take care to discharge properly
¿
before touching the inside of the
device!
Note
If a moisture protection is necessary, mount the
device vertically.
To mount the AM1, proceed as follows:
Unscrew the housing screw and pull off the upper part
¿
of the housing upwards
Mark the fastening points on the wall (centres 5 cm) and
¿
drill the necessary holes
Screw the base part of the housing to the wall using the
¿
screws and wall plugs from the accessory bag
Relocate the upper part of the housing and refasten it
¿
The AM1 is designed for simple connection to RESOL
controllers or calorimeters via the RESOL VBus
ditional power supply connection is not necessary.
For easier access to the terminals, the circuit board can be
taken from its retaining fixture.
Connect the VBus ® cable to the terminals marked „VBUS"
with either polarity.
To the terminals marked „REL", a load can be connected
with either polarity.
The bus cable can be extended with a two-wire cable
(bell wire). The cross section of the cable must be at least
0,5 mm 2 and the cable can be extended up to 50 m in the
case of a single connection.
ATTENTION! Low voltage cables must not run to-
gether in a cable conduit with cables
carrying a higher voltage than 50 V.
Pay attention to the local regulations!
¿
. An ad-
®