Eureka 40 Serie Guia Del Usuario página 8

➂ Cleaning Accessories (Contd.)
➌
➊
➋
8
ENGLISH
HOW TO MAINTAIN
The instructions given in this booklet serve as a guide to routine main-
tenance. To avoid unnecessary service calls, check the hose, dust cup
and motor filter often. Clear a clogged hose, empty the dustcup if it is
full, and clean the motor filter when it is dirty.
CAUTION: Turn off the power switch and unplug the electrical
cord before emptying the dust cup or cleaning the dust
cup filter.
CAUTION: Do not use the cleaner without the dust cup filter prop-
erly installed. This can damage the cleaner.
HINT: Some fine particles can restrict airflow very quickly and will
decrease performance even before the dust container ap-
pears full. For that reason, when vacuuming carpet fresh-
eners or cleaners, powder, plaster dust or similar fine sub-
stances, the dust cup and filter may need cleaning more
often.
Dust Cup and Filter
➀
Pull back on the power switch to the "open cup" position and lift
dust cup away from cleaner.
➁
Remove dust cup filter and dump dust cup in a waste container.
➂
Remove screen from dust cup filter. Screen can be cleaned by
gently tapping against the side of a waste basket.
The dust cup filter can be cleaned by brushing off over a waste
container. Do not allow to get wet.
The dust cup can be rinsed under running water and completely
dried before replacing on cleaner. We do not recommend put-
ting it in a dishwasher.
➃
Replace the dust cup screen onto the dust cup filter, replace the
dust cup filter into the dust cup.
➄
Put bottom edge of dust cup in a cleaner as shown above and
rotate down against cleaner firmly. Dust cup latch will automati-
cally lock.