Call-Ring Tone - Zodiac ZD-360 Manual De Usuario

The level of VOX sensitivity is shown by a number on the LCD screen. At the highest level, the units
will pickup softer noise (including background noise); at the lowest level, it will pick up only quite loud
noise.
a. Press the MENU button 4 times, "VOX" icon will be displayed and "OFF" flashes on the LCD
screen.
b. Press the UP button to set the VOX sensitivity into maximum level (the maximum level is "3".)
To deactivate the VOX function, press the DOWN button until "OFF" appears on the LCD
screen.
c. Press the PTT button to confirm your setting. "VOX" will steadily appear on the LCD screen as
along as the VOX feature is activated.
VOX operation is not recommended if the ZD-360 will be used in a noisy or windy environment.
3.8 Activating the Auto Channel Scan
Channel scan perform searches for active signals in an endless loop for all 8 channels, 38 CTCSS codes
and all 83 DCS codes.
Press the MENU button 5 times, "SCAN" icon will display on LCD screen.
a.
b. Press the UP or DOWN button to begin scanning channels when an active signal is
detected, channel scan pauses on the active channel.
c. Press the MENU button six times, CTCSS flashes on the LCD screen press the UP or
DOWN button to begin scanning the CTCSS from 1-38.
d. Press the MENU button seven times, DCS flashes on the LCD screen. Press the UP or
DOWN button to begin scanning DCS code 1-83.
e. Press the PTT button to confirm your setting.
3.9 Vibrator and Call alert
Your ZD-360 can alert you to incoming signal by emitting an audible call tone and vibration signal.

4. CALL-RING TONE

You can send a Call-ring tone to other PMR users to give an alert that you want to communicate
with them.
Press the CALL button
Yu will hear a ring tone for about two seconds; "TX" icon appears on the LCD screen. Any other
units within the transmitting range and tuned to the same channel and sub-channel (if applicable)
will hear the Call-ring tone.
4.1 Selecting a Call- Ring tone
The ZD-360 is equipped with 15 different types of Call ring tones.
a. Press the MENU button 8 times, the "C01" icon will display and blinking on the LCD
Screen.
b. Press the UP or DOWN button to select the desired call ring tone. A respective call ring
tone sound will be played when changing from one tone to another.
c. Press the PTT button to confirm your setting.