Mounting; Installation Dimensions - Waldmann FLAT TEC MZAC 211 Instrucciones Para El Uso

GB Instructions for Use Machine Light MZA(C),MZE(C) "FLAT TEC"
Assembly
26
Caution
Danger due to insufficient
fastening!
When mounted incorrectly, the
light may fall down.
¾ The light must be positioned
stable on the mounting surface
by means of screws or other
suitable adapter units.
When using mounting elements
¾
which have not been proposed
by the manufacturer, the user
has to verify their reliability!
Mounting to an even surface
¾
suitable for mounting only!
Mounting by a skilled electri-
¾
cian only!

Installation dimensions

The required installation dimensions
are indicated in the drawing Fig. 51
on page 34 and in the table on
page 35.
Note: For special models, the hole
pattern can differ from the standard
hole pattern.
Fastening with screws
When mounting the light, tighten
the screws only slightly at all fixing
points.
When finally fastening the light,
start with the inner screws. Then
tighten the screws from the top
towards the bottom and from the
left to the right side (see example
in Fig. 12).
Fig. 12