Important Instructions; Cleaning And Maintenance; Safety Cautions - Remington sleek & smooth slim Manual Del Usuario

ENGLISH
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, press and hold the on-off switch until the LCD lights up to switch the
straightener on.
When the LCD temperature display reaches the desired temperature the styler is ready to
use.
For extra protection and best results, section hair prior to straightening and spray with heat
protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.
Take care not to hold your hand over the temperature setting switches while styling, as this
could lead to altering the temperature by mistake.
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF A
RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL OPERATING
CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN FOR
ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM,
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR OTHER
VESSELS CONTAINING WATER OR OTHER LIQUIDS.
2
100207 REM IFU S5500_21L.indd GB_2 100207 REM IFU S5500_21L.indd GB_2
INSTRUCTIONS FOR USE

IMPORTANT INSTRUCTIONS

CLEANING AND MAINTENANCE

SAFETY CAUTIONS

01.04.10 12:09 01.04.10 12:09