AKG CU 40 Modo De Empleo página 10

rules. Never throw batteries into a fire
(risk of explosion) or garbage bin.
3. When scrapping the equipment,
separate the case, circuit boards,
and cables, and dispose of all com-
ponents in accordance with local
waste disposal rules.
10
2 Description
2.1 Introduction
Thank you for purchasing an
AKG product. This Manual contains
important instructions for setting up and
operating your equipment. Please take a
few minutes to read the instructions
below carefully before operating the
equipment. Please keep the Manual for
future reference. Have fun and impress
your audience!
2.2 Unpacking
1 CU 40 charger 1 AC adapter
Check that the package contains all the
parts shown above. If anything is miss-
ing, please contact your AKG dealer.
2.3 Description
The CU 40 is a charger specifically de-
signed for use with WMS 40 microtools
Series transmitters.
The charger features three charging
receptacles specially shaped to accept the
GB 40, MP 40, SO 40 transmitters.
Therefore, you will not need to remove the
battery from the transmitter for charging.
Special charging contacts on the bottom
of each charging receptacle automati-
cally close the charging circuit for the
battery inside the device you inserted.
A red/green bicolor LED indicates the
current operating status of the charger.
The rear panel DC IN jack accepts the
DC cable on the supplied AC adapter.