Audiovox NPD 5500 Instrucciones De Montaje página 7

Mounting monitor
A
Never install the monitor in an area where the head could impact in case of an
accident!
A
Observe safety standards concerning the driver's field of vision and airbag inflation
area!
The monitor can be fastened with a support which is available on the market for
accessories.
Depending on the type of monitor (4:3 or 16:9 display) you use you can select the
rectification for guidance pictograms. The system is adjusted to a 16:9 diplay by factory
default.
Installing holder for the remote control (optional),
Mounting on angle bracket
Screw holder to angle bracket. Either insert angle bracket into an available slot or
screw it in place.
Mounting with adhesive plate
Snap holder onto plastic plate. Remove protective paper from adhesive tape. Stick
holder with adhesive plate onto mounting surface and press firmly.
Note: Mounting temperature should be at least 60 degrees Fahrenheit to ensure the
full adhesive effect of the tape.
Completing electrical connections,
Lay all cables carefully. Refer to the connecting diagram on page 3 and to the table
below.
Power supply cable (ISO connector A):
Pin no. Cable color Connection
A1 black/white Speedometer signal input, digital (long cable)
A2 white/yellow Back-up lights (reversing signal)
A3 black/white Speedometer signal input, analogue (short cable)
A4 red +12V permanent power supply - fuse 10 A if necessary
A5 white/blue Switch input "Accessory"
A6 grey Switch input low beam (do not connect to dashboard illumination!)
A7 violet +12V switched - must not be interrupted during engine start
A8 brown Negative battery pole
G = connection required
❍ = connection optional
A
Only connect electrical signals to appropriate terminals in the vehicle.
A
In the case of a direct connection to the battery secure the positive connection (red
lead) with a 10 A fuse close to the battery (approx. 10 - 15 cm).
1. Connect the free cable ends A4, A7 and A8 of the power supply cable to suitable
terminals in the vehicle according to the connecting diagram and the table.
2. Do not cut off unused cables! Wind them together and tie them back! They may be
used later to install additional features.
ill. 8 - 9
ill. 10
G
G
❍
G
❍
G
G
G
4