CAME 001CS1BNC0 Manual Del Usuario página 8

Porter functions
w
call n2
The functions described in this paragraph are only available in systems featuring a porter station.
call n2
Porter call
Porter call notification
CALL ME
CALL ME
Porter call request
call n2
PROGRAMMING
y For call programming, see the entry panel documentation.
beep
a
CALL ME
EN
b
c
d
4
Accessing programming Press the button
X 5
acoustic signal will confirm that programming has been accessed a.
Programming the melody associated with the call from the entry panel
(1 acoustic signal). To listen to the melodies in sequence, press the button
b. To select the melody and exit programming, press the button
select the melody and continue with programming, press the button
Programming the melody associated with the doorbell (2 acoustic si-
gnals). For this type of programming b c d proceed as previously descri-
bed for "Programming the melody associated to the call from the entry panel".
Programming the number of call rings (3 acoustic signals). press the but-
ton the number of times equal to the number of rings selected for the call
(from 1 to 6 rings) e. 3 s after the button is pressed the last time, the call
selected for the selected number of rings will be will be reproduced. To select
the melody and exit programming, press the button
e
Press the button to answer.
The notification is signalled by the Aux2 LED lighting up
. The LED is turned off when communication with the
porter is established.
Porter call request
f
five times within 5 s. A brief
c. To
d.
f.