Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll Rand 46PQ1 Especificaciones Del Producto

Product Safety Information

Intended Use:
These tools are designed to remove and install threaded fasteners.
For additional information refer to Air Pulse Tool Product Safety Information Manual
Form 04584983.
Manuals can be downloaded from www.ingersollrandproducts.com

Product Specifications

Model(s) Style
46PQ1 Pistol Insert Bit
46P3 Pistol Square
56PQ1 Pistol Insert Bit
56P3 Pistol Square
61PQ1 Pistol Insert Bit
61P3 Pistol Square
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K= Vibration measurement uncertainty

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16585747 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
After each 20,000 cycles, or as experience indicates, drain and refill the Impulse Unit Drive
Assembly using the Fluid Replacement Kit (Part No. EQ106S-K400). Lubricate the hex drive and
the output shaft before assembly.
80167588_ed2
Free
Drive
Speed
Type Size rpm
1/4" 9,000
3/8" 9,000
1/4" 8,000
3/8" 8,000
1/4" 6,600
3/8" 6,600
Sound Level dB (A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p
72.6
72.6
75.2
75.2
77.8
77.8
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
EN
Vibration m/s²
(ISO28927)
) Level *K
w
83.6 < 2.5 ---
83.6 3.7 1.1
86.2 3.7 1.1
86.2 3.7 1.1
88.8 < 2.5 ---
88.8 < 2.5 ---
EN-1