Publicidad
C. Power Requirements.
Load consisting of 1 Sound Module:
Load consisting of 4 Light Modules and 1 Sound Module:
D. Electrical Connections.
To avoid electrical shock hazards, do not connect wires when power is applied.
The Sound Module is a plug-in unit completely wired at the factory and does not require
any additional wiring. The Sound Module is controlled by the white/black wire in the Base
(Model LSB). See Table 1. Since the white/black wire also provides control to the Clear Light
Module, a Clear Light Module cannot be installed in a LiteStak which contains a Sound Module.
The control wire for the Sound Module and each Light Module in the LiteStak must be connected
to a control device. See figures 1 through 3 for examples of wiring the modules
to a control device. Control device rating must be capable of handling the power requirements
shown in paragraph C. above. For additional information on Base and Light Module installation
and electrical connections, refer to the appropriate instruction sheets.
E. Sound Module Installation.
Do not install the Sound Module, or any of the Light Modules, when power is on.
The Sound Module must be the top module on the LiteStak.
After wiring of the base is complete, any Light Modules to be installed are assembled to the
Base in the color sequence determined by the user. To install the Light Modules, refer to the
appropriate instruction sheet. The Sound Module is designed to be plugged-in as the top
module on the LiteStak. Up to four Light Modules (LSL's) may be assembled on the Base with
the Sound Module (LSH) installed on top of the uppermost Light Module. The Sound Module
can be assembled directly on the Base provided it is the only module installed.
See figures 1 through 3 for examples of mounting the Sound Module. To install the Sound
Module, proceed as follows:
1. Observe the orientation of the two 3-pin connectors. Position the Sound Module on top
of the Base if it will be the only module, or on top of the uppermost Light Module.
Make sure that the male and female connectors are properly oriented. Align the connectors,
and press the Sound Module until it snaps into place.
2. See figure 4. There are four holes located near the edges of the Sound Module's clear
bottom plate which align with the holes in the Base or Light Module beneath it. To secure
the units together, fully install one snap rivet (supplied with grille kit) in each of the 4 holes.
Press the head of each rivet until it snaps in place.
Damage to the LiteStak can occur if the modules are improperly secured. Check that all four
snap rivets are completely installed in the Sound Module and in each of the
The snap rivets may be pried out with a flat blade screwdriver.
WARNING
CAUTION
NOTE
CAUTION
Light Modules on the LiteStak.
NOTE
-2-
0.07A, 24VDC
0.04A, 120VAC
2.07A, 24VDC
0.84A, 120VAC
Publicidad
