Handi ® 620; Description; Connections; Standalone Version - Gorgy Timing HanDi 300 Modo De Empleo

3.1. DESCRIPtIOn

analogue clocks in standalone versions or receiving pulses, aFnOR nFs 87500 / iRiG-B
122, DCF, Radio DHW (869 MHz), or nTP.

3.2. COnnECtIOnS

To reset the clock switch it off and on by the "ON" / "OFF" located on the
rear face of the clock (except the DCF receiving version).
With the waterproof version, open the clock to make the adjustment.

3.2.1. StanDaLOnE VERSIOn

► set the time, use the wheel on the back of the movement.
☛
With the waterproof version, open the clock to make the adjustment.
X 6
► Close the clock.
► Depending on the power supply option, insert the batteries in their housing or plug
the clock into the mains.

3.2.2. IMPULSE RECEIVER VERSIOn

► Connect the clock to the impulse line as shown
below in the figure opposite.
► Open the clock by unscrewing the bottom of the
clock.
► To set the time on the clock manually, use the
knob on the back of the movement.
36
X 6
3. hanDI 620
®
X 8
1 2 3
B1
min.
MDE-HANDI-2078V2.0