Hardware Installation - Belkin F5U271ea Manual Del Usario

Installation Procedure for Windows
c)
1
___

Hardware Installation

2
2
___
3
Important Note
___
ports until the installation process has been completed.
4
___
1.
Note
most USB devices.
2.
Important Note
host in order to function in Hi-Speed mode (480Mbps data rate). If the Hub
is connected to a USB 1.1-compliant host, it will operate only in low-speed
or full-speed mode (1.5Mbps/12Mbps).
8 EN
Windows 98 SE does not support mass-storage devices; therefore,
the Belkin driver must always be installed.
: Please do not connect any USB devices to the Hub's
Plug the AC adapter into a wall outlet or surge suppressor. Plug
the DC connector into the DC power jack found on the rear of the
Reader.
: The hub may be used without the power supply with
Plug the flat end (USB-A connector) of the provided USB device
cable into the downstream port of your computer, or downstream
port of another hub. Plug the small end (USB-B mini-B connector)
into the USB-B mini-B connector on the back of the Reader.
: The Reader must be connected to a USB 2.0-compliant