ATON DHSIP SOURCE INPUT WALL PLATE Manual Del Usuario página 10

DHSIP Source Input Wall Plate
Installation
The DHSIP is designed to mount in a standard single-
gang rough-in box (J Box). Mount the unit in close
proximity to the location of the source that will be
connected to it.
Note: Do not mount the DHSIP in the same
rough-in box as high voltage devices such as
electrical outlets or switches.
After running Cat-5 and terminating the ends, route
the wire into the back of the rough-in box, connect it
to the RJ-45 connector on the rear of the DHSIP, and
mount using the 2 provided screws. See Figure 2.2.
Rough-In
Screw
Box
Screw
DHSIP
Screw
Screw
Cat-5
Figure 2.2: Installing the DHSIP
8
Stud
©2008 • All rights reserved.