Canopy Assembly; Blade Assembly - Ellington Craftmade MAJ52ABZ5 Guia De Instalacion

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket
to determine which 2 screws in hanging
bracket align with slotted holes in canopy, and
then lower canopy and partially loosen these 2
screws. Remove the other 2 screws and set
aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in canopy with loosened
screws in hanging bracket. Twist canopy to
lock. Re-insert the other 2 screws and secure all
screws with Phillips screwdriver.

9. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
one blade arm with lock washers and blade
arm screws. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
plastic
motor
lock
lock washers
page 7
hanging bracket
canopy
motor
housing
blade attachment
screws and washers
blade arm
blade arm screws
blade