Canopy Assembly - Ellington AVL56BNK5RW Guia De Instalacion

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL with
wire connectors provided as shown in diagram at
right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended for
use. Write down number sequence for use in Section 10.
NOTE: Since this fan does not come with a light kit,
set the dimmer switch (labeled "D" and "X") in the
"OFF" position (X).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall
control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screwheads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
*Remember that antenna for remote control receiver
must rest outside of hanging bracket.
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black
(AC IN from
breaker box)
(wiring for wall control)
antenna
screw
canopy
page 6
wall
control
plate
green
black (OUT to fan)
black
black
(TO POWER supply)
hanging bracket
screw
canopy cover
code
switches
dimmer
switch