Installation - Glacier bay HD58101-X5110H Guía De Uso Y Cuidado

Installation

1
Installing the 1/2" pipe nipple
□
Apply thread sealant tape to both
threaded ends of the 1/2" pipe nipple, H or I;
whichever is needed for the application.
NOTE: This product includes two pipe nipples, but only one
will be used during installation. When installed, the nipple
should extend no more than 1/2" (12mm) past the nished
wall, and no less than 1/4" (7mm) past the nished wall. One
of the two included nipples should work for your application,
but if neither size works for your application, you can nd a
variety of pipe nipple sizes at your local Home Depot store.
3-Option 1
Suction Installation
□
Turn the seat (E1) counterclockwise to remove it
from the slide bar (E).
□
Push the suction assembly (J) and clamping
plate (K), by order as shown below, tight to the wall.
NOTE: Clean the wall before installation and make sure the
wall's surface is smooth (like glass wall or glaze tile).
23.34"
25.74"
H or I
3/8±1/8"
E1
J K
2
Installing the connector
□
Screw connector (B) in a clockwise motion onto
the outlet pipe nipple.
3-Option 2
Tape Installation
□
Turn the seat (E1) counterclockwise to remove it
from the slide bar (E).
□
Put the tape (L) and seat (E1) on the wall by order
as shown below.
NOTE: Make sure the wall is clean and there are no rough
surfaces and gaps on the wall.
23.34"
25.74"
5
Please contact 1-855-HD-GLACIER for further assistance.
B
E1
L E1
HOMEDEPOT.COM