Publicidad
To Install in a cabinet:
1
NOTE: Do not separate the catch from
the yellow template.
1 Using the pull tab, remove the red
adhesive backing from the catch.
2
Don't remove paper from the
yellow template yet.
2 Open the cabinet and hold the
catch with the adhesive facing
upward as shown.
3
3 Place the catch roughly 1 inch (2.5
1" (2.5 cm)
cm) away from the corner of the
frame (close to door handle).
Align inside face of yellow
template with cabinet frame (as
seen in Figure 3).
4 Remove the white paper from the
4
adhesive on the yellow template
and firmly close the cabinet door.
5
5 Open the cabinet door. The yellow
template will adhere to the door
and separate from the catch.
6 Using the pull tab, remove the red
6
adhesive backing from the lock.
7
7 With the lock set to the unlocked
position, align the two tabs along
the sides of the yellow template.
Press firmly to secure the lock to
the cabinet door.
8
8 Pull the yellow template off of the
cabinet door.
9 Press BOTH the lock and catch to
9
ensure that they adhered firmly.
Allow the adhesive to cure for at
least 24 hours to reach full strength.
Ensure the lock is set to the green
lock icon.
NOTE: If your cabinet requires
10
hardware install as outlined before,
be sure to fasten the 4 screws.
10 Pre-drill screw holes for catch
3/8 inch (0.9 cm) deep. We
recommend using a 7/64 drill bit.
Be careful not to drill through
cabinet door.
11
11 Pre-drill screw holes for lock 3/8
inch (0.9 cm) deep. Use a Phillips
head screwdriver to fasten two
screws through the lock openings
as shown.
1
2
3
1" (2.5 cm)
4
5
6
7
8
9
10
11
3
To Install in a drawer:
NOTE: Do not separate the catch
from the yellow template.
1 Using the pull tab, remove the red
adhesive backing from the catch.
Don't remove paper from the
yellow template yet.
2 Open the drawer and hold the
catch with the adhesive facing
upward as shown.
3 Place the catch roughly 1 inch (2.5
cm) away from side of drawer.
Align inside face of yellow
template with cabinet frame (as
seen in Figure 3).
4 Remove the white paper from the
adhesive on the yellow template
and firmly close the drawer.
5 Open the drawer. The yellow
template will adhere to the drawer
and separate from the catch.
6 Using the pull tab, remove the red
adhesive backing from the lock.
7 With the lock set to the unlocked
position, align the two tabs along
the sides of the yellow template.
Press firmly to secure the lock to
the drawer.
8 Pull the yellow template off of the
drawer.
9 Press BOTH the lock and catch to
ensure that they adhered firmly.
Allow the adhesive to cure for
at least 24 hours to reach full
strength. Ensure the lock is set to
the green lock icon.
NOTE: If your cabinet requires
hardware install as outlined before,
be sure to fasten the 4 screws.
10 Pre-drill screw holes for catch
3/8 inch (0.9 cm) deep. We
recommend using a 7/64 drill bit.
Be careful not to drill through
drawer.
11 Pre-drill screw holes for lock 3/8
inch (0.9 cm) deep. Use a Phillips
head screwdriver to fasten
two screws through the lock
openings as shown.
Publicidad
