Amana RS-1 Guía De Usuario página 18

Maintenance
Leveling Legs
CAUTION:
• Be sure the anti-tip bracket secures
one of the rear leveling legs to the
floor to prevent the range from
accidentally tipping.
The range should be leveled
when installed. If the range is
not level, turn the plastic level-
ing legs, located at each cor-
ner of the range, until
range is level.
LEVELING LEG
Electrical
Connection
Appliances which require
electrical power are
equipped with a three-
prong grounding plug
which must be plugged
directly into a properly
grounded three-hole 120 volt electrical out-
let.
Always disconnect power to appliance
before servicing.
The three-prong grounding plug offers
protection against shock hazards. DO
NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE
POWER CORD PLUG.
If an ungrounded, two-hole or other type
electrical outlet is encountered, it is the
personal responsibility of the appliance
owner to have the outlet replaced with a
properly grounded three-hole electrical
outlet.
17
, cont.
Removal of Gas
Appliance
Gas appliance connectors used to con-
nect this appliance to the gas supply are
not designed for continuous movement.
Once installed, DO NOT repeatedly move
this gas appliance for cleaning or to relo-
cate. If this appliance has to be moved
and/or removed for servicing, follow the
procedure described in the installation
instructions. For information, contact
Maytag Customer Service at 1-800-688-
1120.
To prevent range from accidentally tip-
ANTI-TIP BRACKET
ping, range must be secured to the floor
by sliding rear leveling leg into the anti-
tip bracket.
Oven Bottom
Protect oven bottom against
spillovers, espe-
cially acidic or
sugary spills, as
they may discolor
the porcelain
enamel. Use the
correct pan size to
avoid spillovers and boilovers.
The oven bottom may be removed for
easier cleaning.
To remove:
oven racks. Slide the two catches, located
at each rear corner of the oven bottom,
toward the front of the oven.
Lift the rear edge of the oven bottom
slightly, then slide it back until the front
edge of the oven bottom clears the oven
front frame. Remove oven bottom from
oven.
To replace:
oven bottom into the oven front frame.
Lower the rear of the oven bottom and
slide the two catches back to lock the oven
bottom in place.
1
2
3
When cool, remove the
Fit the front edge of the
Conventional
Surface Burners
(select models)
Under no circumstances are the surface
burner assemblies to be taken apart for
cleaning. The surface burner assembly
can be removed to clean the burner box
area. The two surface burner assemblies
are secured in place during transporta-
tion with screws. Once the range is in-
stalled, these screws may be removed to
allow quick and easy removal of the
burner assemblies.
To remove: Allow the burner assembly to
cool. Lift up cooktop. Grasp the burner
assembly and rotate it slightly toward the
left to release the two tabs on the assem-
bly. Then lift the assembly and pull to-
ward the back of the cooktop until the air
shutter ends on the assembly release from
the valves.
To replace: Insert the air shutter ends on
the burner assembly over the valves and
lower the assembly into place. Be sure to
secure the two tabs on the burner assem-
bly into the two slots on the burner sup-
port bracket which is mounted to the
burner bottom. (NOTE: If the tabs are not
properly inserted into the slots, the as-
sembly may rock and the burners may
not light properly.)