Vermeiren 2217E Manual Del Usario página 2

* Operator control (located on the handlebar,
front side of the tricycle):
1
Because of the wiring, both indications can deviate
a little bit. In that case, take the worst charge level
indication.
7. Charging batteries
L
WARNING:
Risk of injury - Only use the
battery charger supplied to charge the
batteries.
Check the battery on damage before charging the
first time. Press the charge indicator button for 2
seconds to switch on the battery. When no LED of
the charge indicator lights up, the battery may be
damaged. When at least one, but not all LEDs of
the charge indicator is lit, then fully charge the
battery pack before using for the first time.
Do not charge a damaged battery and do not
use it, contact your specialist dealer.
1
Instructions to charge the removed battery:
1. Switch the battery/electric device off.
2. Remove the battery from the battery housing
and prevent dirt or fluids to enter the charging
socket.
3. Connect the charger plug to the battery pack .
4. Connect the charger mains plug into the wall
socket.
5. The LED indicator on the battery charger will
show the status of the charging process:
Red - Charging
Green - Standby / Fully Charged
6. Once the battery is fully charged, remove the
battery charger from the wall socket and the
battery.
For the user instructions of the battery charger you
can refer to the manual that is delivered with your
battery charger.
Subject to technical alterations – vC- 2017-05
VERMEIREN
Opening up new horizons in mobility
When the electric
system is switched
on, the LED's of the
battery charge
indicator  will
indicate the battery
charge level.
To ensure full battery
capacity, completely
charge the battery in
the charger before
using it for the first
time.
The battery can be
recharged at any time
on the tricycle or
while removed from
the tricycle.
8. How to ride
Before using the tricycle in busy or potentially
dangerous areas or roads with heavy traffic,
familiarize yourself with the operation of your
tricycle. Please practice in a wide and open area
like a park. Try out the different assistance levels.
When the assist system is turned ON, the electric
system engages and will provide assistance only
while pedaling. The amount of power depends on
your pedaling force and the assistance level. When
you stop pedaling or reach a speed more than 17
km/h the assistance is switched off automatically.
When the assistance (assistance level: 0) is
switched off you can drive normally with your
tricycle.
The assist system can be activated with the button
"+" on the operator control on the handlebar. The
assistance level can be decreased/increased with
the buttons "-" and "+" on the operator control
mounted on the handlebar.
There are 7 assistance levels:
Assistance
level
0
1
2
3
4
5
6
Start
aid
Changing
assistance
level
9. Switching the Start aid On/Off
With the button "6km/h" the start aid can be
activated. The start aid is limited to 6 km/h. The
start aid can make it easier for you to push or start
the tricycle. It is also convenient while taking sharp
turns.
8. Keys
Your E-tricycle is delivered with 2 keys: main key
and spare key. The key's are identified by a serial
number. Keep the spare key in a safe place and
write the key serial number down for key
replacement.
9. Maintenance
For the maintenance manual of the tricycles refer
to the Vermeiren website: www.vermeiren.com.
LED
No LEDs lit
LED LOW is
blinking
LED LOW lit
LED MED is
blinking
LED MED lit
LED HIGH is
blinking
LED HIGH lit
LEDs indicating
assistance level