Guardian MDS86850E Instructivo Y Garantía Del Usuario página 4

Assembly Instructions
1. C arefully remove the rollator components from the shipping carton. Refer to diagram
(Figure 1) as needed.
2. E xamine all parts for shipping damage. DO NOT use the rollator if there is apparent
damage or if any parts (other than the bag) are missing. If there are missing or
damaged parts, please call Medline Customer Care toll free at 1-800-MEDLINE.
3. Remove plastic cover from wheels. Check all of the wheels to see that they are in good
working order and roll freely.
4. U nfold the rollator by pushing down on the Folding Bracket (I) until the Frame is in full
extension.
5. I nsert the padded backrest (D) so that the padded portion faces the front of the unit.
Push down on the backrest while depressing the the round plastic push button until it
snaps into place.
6. Insert the handlebars (B) so that the handgrips (A) are aligned with the rear wheels.
The brake cables should be on the outside of the handlebars and frame. Ensure excess
brake cable loops towards the front of the rollator.
7. Adjust the height of the handlebars (B) for proper fit. To determine proper height, stand
upright behind the rollator with shoulders relaxed, arms hanging at your side and eyes
looking straight ahead. Standing in this position, the handgrips (A) of the rollator should
be adjusted to a height even with the wrists. This will position the arms at an approximate
20º to 30º bend when using the rollator. Secure the handlebars at the closest hole to the
desired height. Insert the screw from the inside of the rollator through the frame. Attach
the washer so it fits snuggly against the frame. Secure the star knob to the screw. See
Figure 2. (Important: Hand Tighten Only!)
8. Place the bag under the seat.
4
MDS86850E (PIC-00311)
Revised: 02/03/16