Tuning To Preset Stations - Insignia NS-R2000 Guia Del Usuario

Insignia NS-R2000 Stereo Receiver
3 Select a preset number between 1 and 30,
then press the MEMORY button.
OR
Notes
• When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two seconds.
• The station has been stored in memory. When
using the numeric keypad, the station is stored
automatically without pressing the MEMORY
button.
• A stored frequency is erased from memory by
storing another frequency in its place.
• If MEM goes off, start again from step 2.
4 Repeat this procedure to memorize
additional stations.

Tuning to preset stations

To tune to a preset station:
1 Select the tuner as the input source.
2 Press T/P MODE to select the preset mode.
OR
PRESETS lights up.
3 Press the PRESET
Scanning preset stations in sequence
To scan preset stations:
1 Press the PRESETS button on the remote
2 Press the PRESETS button again to stop
www.insignia-products.com
/
receiver.
OR
-OR-
Enter the preset number using the numeric
keypad.
Notes
When using the numeric keypad on the remote
control, press the number you want. If your
number is greater than nine, enter the first digit,
then enter the second digit within two seconds.
control.
OR
The receiver starts scanning the stations in
the preset sequence. Each station is
sampled for five seconds.
scanning.
buttons on the
11