Steelcase Ology Manual Del Usario página 5

®
WARNING
RISK OF SERIOUS INJURY DUE TO PINCH POINTS, TIPOVER, OR POTENTIAL COLLAPSE.
All worksurfaces (provided by Steelcase or by customer) must meet all of the requirements for fasteners, clearance, and dimensional limits as follows:
FASTENERS: Adjustable-height bases include fasteners intended for use with Steelcase worksurfaces.
These fasteners MAY also be suitable for worksurfaces meeting the following criteria:
(HPL or LPL) and backers
Thickness of .984" (25.0 mm) or greater
Any other worksurface construction will require different and/or additional fastening means, to be
determined by the project's designer/architect/engineer
use appropriate threaded inserts and corresponding fasteners or similar attachment means.
In all cases, all fastener locations provided in the base attachment features must be used (e.g. if
attachment cantilever has 6 screw holes, all 6 holes must be used for attachment.)
MANDATORY CLEARANCE: To minimize potential pinch points:
this requirement to minimize the risk of serious injury.
MINIMUM PINCH POINT CLEARANCES MUST BE MAINT
AT ALL TIMES T
DIMENSIONAL LIMITATIONS:
W
cantilevers in the back
Worksurface overhang (distance from side of support cantilever to edge of worksurface) must be
W
W
only for tops that are
Worksurfaces
with High- or Low-pressure laminates
any edge
the worksurface edges on all sides
r.
adjacent obstructions any closer than
the path of travel of the worksurface.
RY.
W
WORKSURFACE
WIDTH
CONNECTOR
WORKSURFACE
OVERHANG IN THE BACK
WORKSURFACE
OVERHANG
WORKSURFACE
DEPTH
FRAME TUBE TO BE SLID
INSIDE CONNECTOR
UNTIL BOTTOMED OUT
(MINIMUM 2.5")
Page 5 of 40
P/N 103781401
Doc # 71606 Rev L