Rangemaster RM50000 Serie Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ducted Configuration
1. Use 6" round metal duct to connect the
duct collar on the hood to the ductwork
above.
2. Use duct tape to make all joints secure
and air tight.
3. Insert the decorative flues setting them on
the hood.
4. Extend the upper flue to the ceiling and
secure with the 2 screws (C).
Ductfree Configuration
1. Turn upper flue section upside
down so air vents are at the top.
Slide upper flue section into
lower flue section.
2. Connect the ductfree plenum to
the upper flue section with (4) flat-
head screws (supplied).
3. Install the reduction on the
discharge collar.
4. Measure the distance from the
top of the reduction to the ceiling.
Cut a length of 5" round metal
duct 5" shorter than this
dimension.
5. Fit duct section over the ductfree
plenum. For best fit, make sure
duct seam is toward the front.
6. Set duct/flue assembly on hood
with top tilted away from wall.
Reach around flue to engage
bottom of duct with discharge
collar on hood. Tilt flue up against wall. Duct seam can be cut to length if necessary.
7. Extend the upper flue to the ceiling and secure with the 2 screws (C).
FASTEN FLUE TO
UPPER BRACKET
WITH SCREWS (C)
FLUE SECTION
DUCTFREE
FLUE SECTION
REDUCTION
DISCHARGE
5
UPPER
(in upper flue section)
PLENUM
LOWER
DUCT
5" ROUND
SEAM
METAL DUCT
COLLAR
DECORATIVE
FLUE
DUCT TAPE
6" ROUND
METAL DUCT
AIR
UPPER
VENTS
BRACKET
MEASURE

Publicidad

Tabla de contenido
loading

Tabla de contenido